Our Products
- CNC Drilling & Tapping Machines (3)
- Broaching Machines, Vertical (3)
- CNC Boring Machines (1)
- Magnetic Clutches/Brakes (1)
- Solenoid Directional Control Valves (1)
- Connectors (1)
Contact Information
Room 301-7A,3/F HongKong Trade Center 161-167 Des Voeux road, Central,HK
Tel: 86-852-30763082
Fax: 86-852-30697029
reinforced reaction injection molding Reaction Injection Molding
Model: reinforced reaction injection molding Reaction Inj
Category: Machine Tools / Broaching / Slotting Machines / Broaching Machines, Vertical
Characteristics
reinforced reaction injection molding Reaction Injection Molding
Specifications
| The characteristic of RIM process is the material flow rate is very high .Then stoste’s viscosity can not be very high .Such as the viscosity of polyurethane mixture is about 0.1 Pa s.and flow rate control at 600 g/s in mold falling . Polyurethane two-component mixture have very high reactivity after injected in the mold ,so it complete curing in ten more minutes .But plastic’s conductivity is not good , so most heat can not release from a large chemical reaction condition , so that the outside temperature are higher than inside, so the curing development is from inside to outside . http://www.youdeprototypechina.com |
Featured products
